Product Details

Brief Introduction

 

The finding of the AC slip ring motor and the dragged machine is achieved by using the feeler ruler to test and adjust the four points above and below the back wheel of the coupling. The reading of the clearance between the upper and lower parts of the coupling should be consistent (or the error should not exceed 0.04~0.05mm), and then the motor shaft and the dragged mechanical shaft are rotated together, 90 degrees is an interval, and the measurement is carried out four times in a week. The alignment of the concentricity of the motor with the machine being dragged allows two dial gauges to be placed on one side of the coupling. Touch the side of the backrest wheel of the two half couplings respectively, and adjust the zero position of the two dial gauges. Once the dial gauges are fixed, do not move again. The motor shaft rotates 360 degrees with the shaft of the dragged machine, and the Pointers of the two dial gauges

 

The original reading should be the same and repeated. Otherwise, re-check whether the dial table is firmly installed, if it is confirmed that the two axes are different, it must be re-adjusted, and when the two thousand meter counts within 0.04~0.05mm, it is considered satisfactory. After the adjustment is completed, slightly tighten the adjustment screws around the motor to prevent the motor from moving when pressing the motor foot bolt. The pressing foot bolt must be tightened diagonally and evenly. After tightening, use the above method to find the right again.

 

Main Technical Parameters

 

Frame	H800mm
Power Scope	800kW~1250kW
Voltage	6kV
Frequency	50Hz, 60Hz
Number of Poles	16P
Speed	371rpm
Cooling Mechod	IC611
Protection Grade	IP55
Insulation Class	F(155℃)
Duty	S1
Mounting Type	IM B3

 

Outline Dimensions

 

 

 

Motor Parameters