Product Details

Title

 

Brush DC Generator

 

Brief Introduction

 

When lift Z2 series brush dc generator, only lifting ring shall be lifted. Check bearing grease after box-opening if the motor has been stored beyond two years, replace if necessary. Motor installation areas should have fluent ventilation without hinder, what's more, the emitted hot air should be avoided to enter into the motor directly.

 

The motor must be installed on steel structure pedestal with enough steel rigidity, or cement pedestal. During concrete pouring, (around 2mm) gasket should be added between motor supports and cement pedestal so as to correct the adjustment. During connection between motor and working machine, two axles should be concentric, thus, careful calibration and check should be conducted.

 

Main Technical Parameters

 

Frame	#51
Power Scope	2.2~13KW
Voltage	110V/220V
Exciting Mode	Shunt Exciting
Speed	3000rpm,1500 rpm, 1000rpm, 750rpm
Cooling Method	IC01
Protection Grade	IP22
Insulation Class	B (120℃)
Duty	S1, S4, S5, S6, S9
Mounting Type	IM V15

 

Outline Dimensions

 

 

Motor Parameters